Need help?Do you have a question about the JDS Labs ATOM AMP and is the answer not in the manual?
General| THD+N 1 kHz, 150mW @ 32 ohms | <0.001% |
|---|---|
| THD+N 1 kHz, 100mW @ 300 ohms | <0.001% |
| Input Impedance | 10 kOhms |
| Output Power @ 32 Ohms | 1W |
| Output Power @ 300 Ohms | 125mW |
| THD+N | <0.001% |
| Frequency Response | 20 Hz - 20 kHz |
| Inputs | RCA |
| Outputs | RCA |
Contact information for online support via email and website.
Phone number and operating hours for customer support.
Mailing address for physical correspondence.
Connect AC power adapter to the rear power jack and wall outlet.
Connect audio source to input jacks and select the correct input.
Connect headphones to the front headphone output jack.
Turn the volume knob clockwise to power on the device.
Slowly raise the volume knob to an appropriate listening level.
Details on selecting between 3.5mm and RCA inputs.
How to toggle and use low or high gain amplification.
Input source requirements and safety precautions for DC offset.
Diagram showing audio path when headphones are connected.
Diagram showing audio path when headphones are disconnected.
Cause and solution for the amplifier not powering on.
Solution for the amplifier remaining on due to stuck relays.
Identifies input mode or cable/source issues for no sound.
Troubleshoots issues with single-channel audio playback.
Warning about using incorrect power adapters and potential damage.
Details on the AC-to-AC transformer type, voltage, current, and connector.
To Next Page