General Information and Specifications – 10
Table 3: Operating Specifications
Local control
• Step-up, step-down channel selection
• Control of one external relay driver
• IEEE 488.1 address selection
• Return-to-local function
• Language selection
Remote
control
• GPIB interface:
IEEE 488.1 1987 capability SH1, AH1, T6, L4, SR1, PP0, DC1, C0, E1
• RS232 interface:
setting 8 bits, 1200 baud, 1 stop bit, no parity
Command set Revised command set. Capable of emulating command set of JDS
Uniphase SC-0 and SX-0 Series switch models.
Drivers Eight open collector outputs, sink current 100 mA maximum per output
(driver):
• Drivers 1, 2, 3, 4, +5V, and GND (ground) are accessible from back
panel connector
• Drivers 5, 6, 7, and 8 are internal
• Driver 1 can also be controlled from the DRIVER1 key on the front panel
Warm-up time
1
1 hour at 25 °C ambient temperature
1
Applicable for optimum repeatability performance.
Table 4: Other Specifications
Electrical
Input voltage 100 to 240 V AC, 50 to 60 Hz
Power consumption 80 VA maximum
Physical
Dimensions (W x H x D)
standard
with rack-mount kit
1
21.2 x 8.9 x 35.5 cm
48.3 x 8.9 x 35.5 cm
Weight
3.75 kg
Environmental
Operating temperature 0 to 55 °C
Storage temperature -40 to 70 °C
Humidity maximum 95% RH from 0 to 55 °C
1
Rack-mount kit is optional.
To Next Page
Loading...