JDS Uniphase SB Series - Switch Operation and Remote Control

Operating and Maintenance Instructions – 18
Figure 11: Sample Driver Application: Electrical Equivalent of Driver
Caution
Do not exceed 100 mA per driver.
Powering Up the Switch
To power up the switch:
1. Connect the switch to the AC power source with the AC power cord provided.
2. Set the power switch to
I
(on) to initialize the SB switch. All key lamps and status LEDs
light. If no malfunction is detected during power-up, all lamps and LEDs turn off, and the
display reads 0.
Using and Selecting a Channel
To use the switch:
1. Connect a channel to the front of the switch (Figure 12).
Figure 12: Using a Channel