Jedia JSC-132A - Pushing the CHECK Button; Fault Condition Display; New Standard Value Memory; Final Check

6
O
PERATING METHOD (동작󰼿방법)
2)󰼿"CHECK"󰼿버튼을󰼿놀러󰼿체크합니다.
󰼿󰼿󰼿󰼿󰼿체크가󰼿시작되면󰼿"Checking!"󰼿이라는󰼿메세지가󰼿표시됩니다.
2) Pushing the CHECK button to check.
3)󰼿"MEMORY"󰼿버튼을󰼿먼저󰼿누르고󰼿있는󰼿상태에서󰼿"CHANNEL"󰼿버튼
󰼿󰼿󰼿󰼿을󰼿같이󰼿누르면󰼿현재의󰼿수치가󰼿새로운󰼿기준치로󰼿기억되며󰼿기억되는󰼿
󰼿󰼿󰼿󰼿동안󰼿메모리를󰼿시험하여󰼿그󰼿상태를󰼿표시합니다.
󰼿󰼿󰼿󰼿메모리에󰼿이상이󰼿없고󰼿새로운󰼿기준치가󰼿올바르게󰼿기억되면󰼿
󰼿󰼿󰼿󰼿"Writing󰼿Ok!"를󰼿표시하고,󰼿메모리에󰼿이상이󰼿있거나󰼿새로운󰼿기준
󰼿󰼿󰼿󰼿치가󰼿올바르게󰼿기억되지󰼿않으면󰼿"Back-Up󰼿Error!"를󰼿표시합니다.
󰼿󰼿󰼿󰼿("Back-Up󰼿Error!"가󰼿표시된󰼿경우에는󰼿기기󰼿내부의󰼿해당󰼿메모리를󰼿
󰼿󰼿󰼿󰼿동일한󰼿제품으로󰼿교환하여󰼿사용하여야󰼿합니다.)
3) New standard value will be memoried from current memory,
when pushing the CHANNEL button while memory button
is pushed first and display status of memory as follows
"Writing ok" when new standard value is memoried and
good memory chip without error "Back-up error " when new
standard value is memoried and bad memory with error
(if it displayes "Back-up error"on the LCD, change fault
memory into new one with same type)
4)󰼿한번󰼿더󰼿"CHECK"를󰼿눌러󰼿최종󰼿상태를󰼿체크합니다.
4) One more press the "CHECK" button and finished the process.
C h e c k i n g !
Then, it displayes "CHECKING" on the LCD.
When finishing the CHECK, it displayes detailed value on
the LCD and compare previous memory value .
As a result of compared value between previous one and
new one, if there is discrepancy, it will be displayed status
on the LCD as below.
Differ more than +25% from the measurement : "Line open"
+15% - +25% from the measurement : "Line Imp.-over"
-15% - +15% from the measurement : "Line Good"
-15% - -25% from the measurement : "Line Imp.-under"
less than -25% from the measurement : "Line short"
incase of grand fault, "Ground Fault". Buzzer makes sound
and LED is turn on in case of no" Line Good".
ex). For the previous standard value is 100 and channel
is NO 1, the below is figure.
이󰼿후󰼿체크가󰼿완료되면󰼿체크된󰼿수치가󰼿표시되고,󰼿이전에󰼿기억되
었던󰼿기준치와󰼿비교된󰼿후󰼿그󰼿상태가󰼿표시됩니다.
표시되는󰼿상태는󰼿이전에󰼿기억되었던󰼿기준치와󰼿비교하여󰼿기준치의󰼿
+25%󰼿이상은󰼿"Line󰼿Open!",󰼿기준치의󰼿+15%󰼿󰾝󰼿+25%󰼿까지는󰼿
"Line󰼿Imp.-over!",󰼿기준치의󰼿-15%󰼿󰾝󰼿+15%󰼿까지는󰼿"Line󰼿Good!",󰼿
기준치의󰼿-15%󰼿󰾝󰼿-25%󰼿까지는󰼿"Line󰼿Imp.-under!",󰼿기준치의󰼿
-25%󰼿이하는󰼿"Line󰼿Short!",󰼿그라운드󰼿폴트인󰼿경우에는󰼿"Ground󰼿
Fault!"가󰼿표시됩니다.
또한󰼿Line󰼿Good󰼿상태가󰼿아닌󰼿경우에는󰼿폴트상태를󰼿나타내기󰼿
위하여󰼿부저음이󰼿울리며󰼿이와󰼿동시에󰼿LED가󰼿점멸됩니다.
예)채널이󰼿1번이고󰼿이전에󰼿기억되었던󰼿기준치가󰼿100󰼿이였을󰼿경우의󰼿
󰼿󰼿󰼿󰼿상태표시.
C h 0 1 1 2 5
L i n e O p e n !
C h 0 1 W A T T7 5
L i n e S h o r t !
G r o u n d F a u l t !
C h 0 1
C h 0 1 8 0 W A T T
W r i t i n g O k !
C h 0 1 8 0 W A T T
B a c k - U p E r r o r !
C h 0 1 1 0 0
W A T T
W A T T
C h 0 1 1 0 0
W A T T
L i n e G o o d !
L i n e I m p . - o v e r !
C h 0 1 1 1 5
W A T T
L i n e I m p . - u n d e r !
C h 0 1 8 5
W A T T