To Turn Off
The system will turn off and clear the set speed in
memory if:
• You push the Adaptive Cruise Control (ACC) ON/
OFF button.
• You push the Normal (Fixed Speed) Cruise Control
ON/OFF button.
• You turn OFF the ignition.
• You switch to Four-Wheel Drive Low.
To Resume
If there is a set speed in memory press the RES (resume)
button and then remove your foot from the accelerator
pedal. The EVIC will display the last set speed.
NOTE:
• If your vehicle stays at standstill for longer than 2
seconds, then the driver will either have to press the
Resume button, or apply the throttle to reengage the
ACC to the existing Set Speed.
• ACC cannot be resumed if there is a stationary vehicle
in-front of your vehicle in close proximity.
WARNING!
The Resume function should only be used if traffic
and road conditions permit. Resuming a set speed
that is too high or too low for prevailing traffic and
road conditions could cause the vehicle to accelerate
or decelerate too sharply for safe operation. Failure to
follow these warnings can result in a collision and
death or serious personal injury.
196 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
To Next Page
Loading...
