Rear Hard Top Removal
1. Remove both front panels. Refer to “Front Panel(s)
Removal” in this section.
2. Open both doors.
3. Remove the two Torx® head screws that secure the
hard top at the B-pillar (near the top of the door) using
a #40 Torx® head driver (Four–Door Only).
4. Remove the six Torx® head screws that secure the
hard top to the vehicle (along the interior bodyside)
using a #40 Torx® head driver.
5. Open the swing gate all the way to ensure clearance of
the rear window glass. Lift the rear window glass.
6. Locate the wire harness on the left rear inside corner of
the vehicle.
212 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
To Next Page
Loading...
