Installation and Operation
T
he Power Supply is normally installed directly on top of the companion
Preamplifier. Be sure to install the supplied compliant isolation interface
supports between each unit and underneath the Preamplifier to avoid
damage to chassis components and provide maximum mechanical isola-
tion and decoupling from the supporting structure.
First, connect the supplied DC Power Cable (
1) between the Preamplifier
and Power Supply, as illustrated above. Then connect the AC mains to the
Power Supply using the supplied AC Power Cable. If desired, the
Preamplifier can be located up to twenty (20) inches (one half (0.5) meter)
above or below the power supply. The use of a longer DC power cable
offering greater separation distance is not recommended.
The Power Supply is intended to operate connected to active AC mains at
all times. In the event of a short or long term loss of AC power, the
preamplifier outputs will automatically mute. When full AC power is
restored, all previously programmed settings will be lost and the volume
control will reset to 0.
The Coherence Preamplifier utilizes circuit technologies which require a
much longer “break-in” period than other preamplifier designs. It is
recommended that a period of at least eight (8) days (200 hours) of
continuous operation be allowed before full sonic performance potential
can be expected.
Installation and Operation
To Next Page
Loading...
Need help?
General
