Jegs 79000 - User Manual

Installation Instructions for 79000
2-Ton Hydraulic Jack
SPECIFICATIONS
Capacity (Ton)
Lift Range
2
5-1/8" to 13"
1-800-345-4545 jegs.com
Owner and/or Operator Responsibility
The owner and/or operator shall read, study and understand the
product instructions and retain them for future reference.
Operation
The owner and/or operator shall have an understanding of the product
and safety operating instructions before operating the product. Safety
information shall be emphasized and understood. If the operator is not
fluent in English, the product warnings/cautions and instructions shall
be read to and discussed with the operator in operator’s native
language by purchaser/owner or his designee, insuring that the
operator comprehends their content.
Inspection
(a) Visual inspection MUST be made prior to each use of the jack.
Check for cracks, cracked welds, missing or damaged parts.
(b) Keep all moving parts clean and well lubricated.
(c) Owners and/or operators should be aware that repair of this
equipment may require specialized knowledge and facilities. It
is recommended that an annual inspection of the product be
made by a manufacturer or supplier’s authorized repair facility
and that any defective parts, decals, or safety labels and signs
be replaced with manufacturer or supplier’s specified parts.
Damaged Equipment
Any jack that appears to be damaged in any way or is found to be worn
or operates abnormally SHALL BE REMOVED FROM SERVICE
IMMEDIATELY UNTIL REPAIRED. It is recommended that a
manufacturer or supplier’s authorized repair facility make necessary
repairs if the manufacturer or supplier permits repairs
Alterations
Because of potential hazards associated with the misuse of equipment
of this type, NO MODIFICATIONS/ALTERATIONS shall be made to the
product.
Attachments and Adaptors
Only attachments and/or adaptors supplied by the manufacturer shall
be used.
 Read, study and understand all instructions before operating
this device.
 Do not exceed rated capacity. Over-loading may cause damage
to/or failure of the jack.
 Always use only on hard, level surface. Do not use equipment
on slopes or angles.
 Lifting device only. Jack must not be used as a jack stand to
hold loads for prolonged periods of time.
 Immediately after lifting, support the vehicle with appropriate
means. Use jack stands in pairs to support loads. Inspect jack
stands before use as indicated by the manufacturer’s owner’s
manual.
 Lift only on areas of the vehicle as specified by the vehicle
manufacturer’s owner’s manual.
 Center load on the jack saddle. Off center loads can cause loss
of load or damages to load and/or equipment.
 Never work directly under a supported load.
 Do not move or dolly the vehicle while on the jack.
 Place wheel chocks under vehicle wheels on both sides to
prevent rolling.
 Use in dry, well lit areas.
 Keep children and bystanders away. Children must never be
allowed in work area. Do not let children play on or around jack
or lifted load.
 Any jack that appears to be damaged in any way or is found to
be worn or operates abnormally SHALL BE REMOVED FROM
SERVICE IMMEDIATELY UNTIL REPAIRED. It is
recommended that a manufacturer or supplier’s authorized
repair facility make necessary repairs if the manufacturer or
supplier permits repairs.
 Because of potential hazards associated with this type of
equipment, NO ALTERATIONS SHALL BE MADE to this
product.
 Only attachments and/or adapters supplied by the manufacturer
shall be used.
 Failure to heed these warnings may result in property damage,
personal injury and/or death.
WARNING

Summary

Owner and;or Operator Responsibility

Operation

Guidance on product operation and safety instructions for the operator.

Inspection

Visual inspection procedures and recommendations for annual product inspection.

Damaged Equipment

Procedure for handling damaged or abnormally operating jacks.

Alterations

Prohibition of modifications or alterations to the product due to potential hazards.

Attachments and Adaptors

Requirement to only use manufacturer-supplied attachments and adaptors.

General Safety Warnings

Operation Procedures

To Lift

Step-by-step instructions for lifting a vehicle using the hydraulic jack.

To Lower

Step-by-step instructions for lowering a vehicle safely with the jack.

Maintenance and Troubleshooting

Maintenance

Mandatory visual inspection before each use and recommended annual inspection.

Troubleshooting

Common problems like saddle not rising or erratic lift with possible causes and remedies.

Fluid Management

Check and Refill Oil

Instructions for checking and refilling hydraulic jack oil using specific jack oil.

Air Purge Procedure

Steps to purge air from the hydraulic system for improved lift performance.

Jegs 79000 Specifications

General

Model	79000
Type	Floor Jack
Capacity	3 Ton
Material	Steel
Lifting Capacity	6000 lbs
Color	Red
Maximum Saddle Height	19.75 inches