JEM Glaciator X-Stream User Guide

JEM Glaciator X-Stream

12 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

Martin Professional A/S,Olof Palmes Allé 18, DK-8200,Aarhus N

Phone: +45 87 40 00 00 Internet: www.martin.dk

Heavy Fog

Glaciator

X-Stream

USER GUIDE

VERSION 1.0

Table of Contents

Other manuals for JEM Glaciator X-Stream

User Manual40 pages

Questions and Answers:

C
Cynthia BakerAug 3, 2025
Why is my JEM Glaciator X-Stream Fog Machine not producing fog when using the fog or timer switch?
- K
  Kimberly JacksonAug 3, 2025
  If your JEM Fog Machine isn't producing fog when using the Fog or Timer switch, several factors could be at play. First, ensure the machine has had adequate time to heat up. Check that the fluid level isn't below the minimum; if it is, add more fluid. Also, verify that the Standby switch is set to ON. Finally, if you're using the timer, confirm that the on-period (ton) is set to at least 1 second.
A
Allison RuizAug 9, 2025
What to do if JEM Glaciator X-Stream Fog Machine has no fog output when using DMX?
- E
  Emma SullivanAug 9, 2025
  If your JEM Fog Machine isn't emitting fog when triggered via DMX, there are a few things to investigate. Begin by checking the DMX address settings to ensure they are correct. Then, allow the machine sufficient time to warm up with the DMX signal active. Lastly, confirm that a 120 Ohm resistor is fitted for DMX termination.
G
george03Aug 14, 2025
Why JEM Glaciator X-Stream Fog Machine is not ready after 20 minutes heating time?
- N
  Nicole TorresAug 14, 2025
  If your JEM Fog Machine is not ready after a 20-minute heating period, start by checking that the Standby switch is set to ON. If the issue persists, the fuse on the Power control PCB may be blown. Disconnect the power supply and replace the fuse.

JEM Glaciator X-Stream Specifications

General

Brand	JEM
Model	Glaciator X-Stream
Category	Fog Machine
Language	English

Related product manuals

Preview: JEM ZR12-DMX