To Next PageTo Next Page
Need help?Do you have a question about the Jenn-Air JDB2150AWP0 and is the answer not in the manual?
General| Type | Built-In |
|---|---|
| Width | 24 inches |
| Energy Star Certified | Yes |
| Wash Cycles | 5 |
| Control Type | Electronic |
| Number of Options | 4 |
| Soil Sensor | Yes |
| Third Rack | No |
| Stainless Steel Tub | Yes |
| Delay Start | Yes |
| Water Heater | Yes |
| Drying Option | Heated Dry |
| Height | 34.5 inches |
| Depth | 24 inches |
Includes instructions, energy guide, and use/care guides for dishwasher parts.
Components like door insulation, foam barrier, foam block, and wrap for the dishwasher door.
Includes hinge brackets, door handle, and front panel components for the dishwasher.
Parts for the toe kick area, including insulation, damper, and front support.
Main housing and control board for the dishwasher's electronic interface.
Includes the inner control panel and door switch for the user interface.
Components for the door latch mechanism and the user interface controls.
Electrical wiring harness and bottom door seal for the dishwasher.
Includes the rinse aid dispenser, cap, and mounting bracket.
Inner door panel and insulation with damper for the dishwasher.
The complete lower wash arm, including its cap and radiant shield.
The main heater element with gasket, essential for water heating.
Includes nuts and bracket for securing the heater element.
Hoses for water inlet and draining, including spring clamps.
Components for water entry, including the main water valve and air inlet.
System for detecting and preventing overfilling, with float, standpipe, and switch.
Door strike mechanism and the door cable assembly for operation.
Brackets, rollers, and adjustments for mounting the dishwasher cabinet.
Seals and insulation for the door and tub to prevent leaks.
Thermostat and associated clips for temperature regulation.
Adjustable legs for leveling and trim strips for the dishwasher exterior.
Seal and grill for the air and water inlet.
Filter guard and assembly, and flowplate for water circulation.
Wash impeller assembly and the main wash motor.
The complete drain pump system, including inlet and flapper.
Sensor for water turbidity and a chopper component.
Capacitor for motor operation and its protective shield.
Dishrack, inner slide rail, cup shelf, and auxiliary basket for the upper rack.
Upper wash arm, manifold, and associated clips.
Lower dishrack, wheel assembly, and silverware basket.
Cage and ball bearings for smooth rack movement.
Tube and bracket for feeding water to the upper wash system.
The top wash arm assembly, including retainer and docking station.
Kits for dishwasher installation, including power cord and fill hoses.
Kit to prevent moisture damage, often used in installations.
Replacement drain hoses of various lengths (6 ft. and 12 ft.).
Paint colors for touching up minor cosmetic damage to the appliance.
