MOUNTINGTHE RANGEHOOD
Begin by determining hood mounting height on wall.
2. Leverand mount the wood paneronto the wall at the appropriate height and secure it to the
studs. This wood paner shourd be 1/2" x 3" and the width will either be 29", 35" or 47"
depending on the width of the hood. Measurethe distance between the wall mounting brackets
and fasten them onto the wood panel.Refer to the diagram for how the brackets attach to the
panel Make sure they wil! fine up with the brackets on the back of the hood.Lift the hood and
hang it onto the brackets.
3. Temporarily removethe baffre filters from hood,and feverhood by adjusting the metal brackets
rocated inside of the hood.(Note:there is approximately lOcm total adjustability up and down).
These brackets areadjusted by a screw that can beeasily turned with yourfingers. There is one
on each side on the inside back wall of the hood.After ensuring that the hood is level,complete
ly tighten the screws to secure the hood to the wall.
4. After the hood is attached to the mounting brackets, you may further secure it by screwing two
screws into the wall from the inside of the hood.There are two screw holes near the bottom that
you can useas a guide.
/
¢
.....
To Next Page
Loading...
Need help?
General
