Need help?Do you have a question about the Jensen A540 DiXL D-1703 Track and is the answer not in the manual?
Measured noise levels of the wood chipper during operation.
Fundamental safety rules for operating the wood chipper.
Guidelines for safe operation, including specific components like PTO shafts and propulsion.
Procedures for machine conditioning, attendance, repairs, and care of components.
References for routine attendance and inspection of the machine.
Specific operating instructions for engine-driven wood chipper variants.
Pre-operation checks and familiarization with instructions.
Essential safety measures to be observed during machine operation.
Recommended protective clothing and procedures for starting the machine.
Regular maintenance tasks to ensure machine performance and longevity.
Table detailing correct tightening torques for bolts and nuts.
Detailed greasing procedures and intervals for the A540 model.
Instructions for operating the machine's undercarriage and movement controls.
Operating instructions for the machine's winch mechanism.
Precautions for operating on soft ground, inclines, and slopes.
Procedures and safety measures for transporting the machine.
Guidelines for the proper use and care of the machine's rubber tracks.
Procedure for checking and adjusting the tension of the rubber tracks.
Identification of common causes leading to damage in rubber tracks.
Steps for safely removing and installing rubber tracks.
Procedure for checking and maintaining the oil level in drive geared motors.
Recommendations for selecting the correct type of oil for reduction units.
General information, transport, and storage guidelines for roller gear.
Steps for mounting, installation, and lubricating the roller gear.
General advice and crucial safety warnings for assembling the CLAMPEX® KTR 400.
Step-by-step instructions for assembling and disassembling the clamping set.
Steps for connecting and adjusting the length of the PTO shaft joints.
Information on safety guards and lubrication for PTO shaft joints.
Instructions for dismantling and assembling the PTO shaft joints.
Introduction to the HMCflex unit, its overview, and key functions.
General information, target group, and important usage instructions for HMCflex.
How to connect, switch on/off, and use the control keys.
Procedures for changing HMCflex settings via menus and diagrams.
Detailed explanations of adjustable parameters for HMCflex configuration.
Concepts of engine speed measurement and temperature-dependent preheating.
HMCflex control of the chipper, inputs, and hardware specifications.
Wiring diagrams and document revision history for the HMCflex.
Detailed wiring diagram for the HMC-Flex electrical feed control system.
To Next Page
General
