What to do if my Jensen Portable Radio has no sound on AM or FM?
If your Jensen Portable Radio produces no sound on AM or FM, ensure the band selector is correctly set to either the AM or FM position. Also, verify that the volume is not set to the minimum level and increase it as needed.
How to fix noise or distorted sound on Jensen MR-550 Portable Radio?
If you experience noise or distorted sound on AM or FM broadcasts with your Jensen Portable Radio, try these steps: First, make sure that you have properly tuned to the AM or FM station. For FM, fully extend the telescopic antenna. For AM, reposition the unit to achieve the best possible reception.
Comprehensive safety guidelines for the product's operation, maintenance, and electrical safety.
Details regarding compliance with Federal Communications Commission radio frequency regulations.
Recommendations for protecting furniture from potential marks or residue from the product's feet.
Identifies and describes all buttons, knobs, jacks, and other controls on the unit.
Information on AC and DC power sources, and how to connect the unit to AC power or install batteries.
Instructions for turning the unit on/off, tuning radio stations, and connecting auxiliary audio sources.
Technical details including power requirements, frequency ranges, and wattage.
Common issues, possible causes, and solutions for operating the radio.
Details of the product's warranty coverage, terms, and conditions for service in the USA.
General| Brand | Jensen |
|---|---|
| Model | MR-550 |
| Category | Portable Radio |
| Tuning | AM/FM |
| Power Source | AC or Battery |
| Headphone Jack | Yes |
| AC Input | 120V AC |
To Next Page