- 3 -
WARNING
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
PROTECT YOUR FURNITURE
This product is equipped with non-skid rubber 'feet' to prevent the product from moving when you operate the
controls. These 'feet' are made from non-migrating rubber material specially formulated to avoid leaving any
marks or stains on your furniture. However certain types of oil based furniture polishes, wood preservatives, or
cleaning sprays may cause the rubber 'feet' to soften, and leave marks or a rubber residue on the furniture. To
prevent any damage to your furniture we strongly recommend that you purchase small self-adhesive felt pads,
available at hardware stores and home improvement centers everywhere, and apply these pads to the bottom
of the rubber 'feet' before you place the product on fine wooden furniture.
LOCATION AND DESCRIPTION OF CONTROLS
POWER SUPPLY
The MR-550 can be operated from the following power sources:
AC: 120V~ 60 Hz
DC: 4 x 1.5V
, battery type R14/ UM-2/ “C” size (not provided)
CONNECTING TO AC POWER AND INSTALLING BATTERIES
1. Insert the plug of Power Cord into a standard wall outlet with a constant AC power supply.
2. Install 4 fresh alkaline batteries into the Battery Compartment following the polarity diagram inside. Use only the
specified size and type of batteries.
IMPORTANT:
1. Dial Mark
2. Tuning Knob with dial scale
3. AM/FM Band Selector
4. AUX IN Jack
5. On/Off Volume Control
6. Speaker
7. Foldable Carrying Handle
8. AC Power Cord (Located Inside the
Battery Compartment)
9. Battery & AC Cord Compartment
10. Swivel FM Telescopic Antenna
To Next Page
Loading...