JessEm Tool Mast-R-Fence User Manual

Tools Required for Assembly
 Phillips screw driver

10 mm wrench or socket
 3/16” Drill Bit*
 1/16” Drill Bit*
*Note: This is required if you are not mounting to a Je
Assembling
the Fence Tracks
There are two different types of fence
tracks depending upon which model
fence you have purchased.
Fence model 04010 (Master Fence)
has a table mounting bracket provided
with a T-
nut slot for mounting
fence to the bracket (Fig 1)
. When
assembling the table mounting bracket
to the fence track use a 6mm hex bolt
with a flat washer and insert the bolt
into the lower slots on the fence track.
Screw the T-
nuts onto the bolts. Slide
the T-nuts into the T-
slot on the table
mounting bracket. Do not tighten this
assembly at this stage.
Fence model 04100 (Router Fence)
has a table mounting bracket but does
not have the T-
slot in the bracket as
Model 04010.
Mount the table bracket
directly to the fence track using 6mm
hex bolts
and flat washers (Fig. 2)
not tighten this assembly at this stage.
Tools Required for Assembly
10 mm wrench or socket
*Note: This is required if you are not mounting to a Je
ssEm table top.
the Fence Tracks
There are two different types of fence
tracks depending upon which model
fence you have purchased.
Fence model 04010 (Master Fence)
has a table mounting bracket provided
nut slot for mounting
the
. When
assembling the table mounting bracket
to the fence track use a 6mm hex bolt
with a flat washer and insert the bolt
into the lower slots on the fence track.
nuts onto the bolts. Slide
slot on the table
mounting bracket. Do not tighten this
Fence model 04100 (Router Fence)
has a table mounting bracket but does
slot in the bracket as
Mount the table bracket
directly to the fence track using 6mm
and flat washers (Fig. 2)
. Do
not tighten this assembly at this stage.
Figure 1
Figure 2

JessEm Tool Mast-R-Fence Specifications

General

Brand	JessEm Tool
Model	Mast-R-Fence
Category	Power Tool
Language	English