Need help?Do you have a question about the JessEm Tool MITE-R-SLIDE II and is the answer not in the manual?
General| Material | Aluminum |
|---|---|
| Height | 4 inches |
| Bar Dimensions | 3/4 inch x 3/8 inch |
| Adjustability | Adjustable for precise cuts |
| Mounting | Table Saw Miter Slot |
Attaching the guard assembly to the guard mount using screws and hex key for protection during operation.
Connecting the roller mount to the gauge assembly with screws and washers for smooth movement.
Securing the Mite-R-Slide II fence to the router table, using paper for precise initial adjustment.
Installing and positioning the left and right hand stop bases on the fence track for cut control.
Mounting the guard assembly to the fence t-slot and centering it over the router bit opening.
Adjusting the fence to be square (90°) with the router table using set screws for accurate cuts.
Adjusting the fence to the 45° mark on the gauge using set screws for precise angled cuts.
Aligning the indicator block on the gauge to the 0° line for accurate measurement and repeatability.
Fine-tuning the roller assembly fit within the track for smooth, consistent operation and zero play.
To Next Page
