MITE- -
SLIDE
II
Model #06100
Thank you for choosing this product from JessEm Tool Company. We appreciate your support and hope that our
product serves you well. This product is designed to provide many years of reliable service provided it is used as
intended and taken care of.
This user manual will assist you in assembly and general operation of this product. It is not our intent to teach you
about woodworking. It is assumed that you are an experienced woodworker with the basic skills and experience
necessary to use this product safely. If after reading the following instructions, if you are unsure or uncomfortable
about safely using this product we urge you to seek additional information through widely available woodworking
books or classes.
As part of our Continuous Product Improvement Policy, JessEm products are always advancing in design and
function. Therefore there may be differences between what is shown in our catalogs, website or at retail display and
what is sold at time of purchase. We reserve the right to make positive changes to our products at our discretion.
61 Forest Plain Road
Oro-Medonte, Ontario,
Canada L3V
0R4
Toll Free:1-866-272-7492
•
Before operating this product, read and understand all safety instructions.
•
If you do not have a manual, contact the manufacturer and obtain one before using any power tool.
•
Always wear eye protection in compliance with ANSI safety standards when operating any power tool.
•
•
Local Phone: 705-726-8233
Fax: 705-327-0295
Email:jessem@jessem.com
Website: www.jessem.com
Do not wear loose clothing or jewelry that may catch on tools or equipment.
Unplug your router when making any adjustments.
Always wear eye protection in compliance with ANSI safety standards when operating any power tool.
•
•
Always use proper guards and safety devices when operating power tools and machinery.
•
Carefully check router bits before each use. Do not use if damage or defect is suspected.
Use reduced RPM speeds for large diameter bits.
•
Never force the bit or overload the router beyond the expectations of the tool.
•
Be sure that at least 3/4 of the shank length is inserted securely in the router collet.
•
Never bottom out the bit in the collet. Allow 1/8” clearance between shank and bottom of collet.
•
Always make sure the fence on your router table is locked into position before each use.
•
Always rout in two or more passes when large amounts of stock must be removed.
•
Do not exceed the recommended RPM for any router bit.
•
•
Before operating any router, read and understand all safety instructions in the owner’s manual that came with
the router.
IMPORTANT SAFETY PRECAUTIONS
ROUTER SAFETY PRECAUTIONS
R
2
To Next Page
Loading...
Need help?
General
