MAINTENANCE
DAILY
• Remove the rack
• Drain and clean out the dishwasher.
• Clean all the scrap screens.
• Clean the wash tank. Do not use abrasives to wash the tank.
• Do not flush food particles down the drain on "DP" (Drain Pump Equipped) Models.
• Verify levels of product for detergent and rinse-aid.
WEEKLY
• Clean wash/rinse-arm jets, and free them of any blockage. Remove the wash/rinse arm assembly by unscrewing
the center knob.
• Turn off the power to the machine. Open the front panel with a screwdriver. Visually inspect the peristaltic pump
for worn tubes.
MONTHLY
• Visually inspect inside the machine for any water or detergent leaks.
SEMI-ANNUALLY
• Replace tubes in peristatic pumps.
• Verify if "O" Rings are worn on wash/rinse arms.
• Rotate upper and lower arm assembly.
ANNUALLY
• A complete verification by a qualified JET-TECH technician is now recommended.
• Treatment for mineral deposits.
• Flush and drain booster.
• Run a few cycles with a de-liming product.
• Electrical verification.
• Check all water and drain connections for any leaks.
• Check all components.
• Check hoses for wear and tear.
To Next Page
Loading...
