Jet AFS-1000B User Manual

6
Contents of Shipping Carton
1 Air Filtration Unit
1 Remote Control
3 AAA Batteries
4 Eye Bolts and Nuts
4 Mounting Brackets
8 Hex Cap Screws
8 Lock Washers
4 Foam Pads
1 Velcro Pad
1 Manual and Warranty Card
Tools Required for Assembly
No. 2 Cross Point Screwdriver
10mm Wrench
 The air filtration unit does not require much
assembly. You should take into consideration
how and where you will place this unit.
 It can be mounted horizontally and vertically.
The unit can also be hung from the ceiling.
 This unit will work best if it is located away from
corners, and heating/cooling vents.
 If using on sawhorses the air filtration unit should
be clamped in place.
 This unit is specifically designed to circulate and
filter non-metallic dust, which is generated
throughout the work area.
Assembly
Mounts must be anchored to
building structure, which will support a
minimum of at least 100 pounds. Never mount
to surfaces such as dry wall, false ceiling grids,
etc.
1. Remove all packing from inside of the unit by
removing the outer filter and inner filters.
2. The air filtration unit can be hung from the
ceiling. Remove four screws from the cabinet
top (A, Fig. 1).
3. Hang the unit using four eyebolts (B, Fig. 1),
and four hex nuts (C, Fig. 1) provided.
Figure 1

Jet AFS-1000B Specifications

General

Model	AFS-1000B
Category	Air Cleaner
Motor Power	90W
Filter Type	HEPA, Activated Carbon, Photocatalyst, UV-C
Power Consumption	90W