6
Introduction
This manual is provided by WMH Tool Group covering the safe operation and maintenance procedures
for a JET Model JPSG-618M1 Surface Grinder. This manual contains instructions on installation, safety
precautions, general operating procedures, maintenance instructions and parts breakdown. This machine
has been designed and constructed to provide years of trouble free operation if used in accordance with
instructions set forth in this manual. If there are any questions or comments, please contact either your
local supplier or WMH Tool Group. WMH Tool Group can also be reached at our web site:
www.wmhtoolgroup.com.
Specifications
Model Number......................................................................................................................JPSG-618M1
Stock Number................................................................................................................................ 414519
Table Size (L x W)(in.) ..................................................................................................................... 6 x 18
Grinding Capacity (L x W)(in.)............................................................................................................ 9 x 7
T-Slot (in.)...........................................................................................................................................9/16
Maximum Longtitudinal Manual Table Travel (in.)...................................................................................20
Maximum Cross Manual Table Travel (in.).........................................................................................7-3/4
Cross Handwheel Graduation (in.) .................................................................................................. 0.0005
Cross per Handwheel Revolution (in.)...................................................................................................0.2
Maximum Spindle Centerline to Table (in.).............................................................................................18
Vertical Handwheel Graduation (in.)................................................................................................ 0.0001
Vertical per Handwheel Revolution (in.)...............................................................................................0.05
Maximum Wheel Diameter (in.)................................................................................................................8
Maximum Wheel Thickness (in.) ...........................................................................................................3/4
Wheel Center Bore (in.) .....................................................................................................................1 1/4
Spindle Speed (RPM) ....................................................................................................................... 3,450
Main Motor (TEFC)...................................................................... 2 HP, 3 Ph, 230V/460V Prewired 230V
Floor Space Required (L x W x H)(in.).....................................................................................74 x 45 x 68
Net Weight (lbs.)...............................................................................................................................1,585
The above specifications were current at the time this manual was published, but because of our policy of
continuous improvement, WMH Tool Group reserves the right to change specifications at any time and
without prior notice, without incurring obligations.
To Next Page
Loading...
