Jetboil Genesis - Storage and Maintenance; Storing the Stove; Maintenance Procedures

12
Storing after use:
• Allow stove to cool before storing.
• Always disconnect fuel cylinders before storing the stove.
• Ensure stove is clean and dry before storing.
• Store the stove in a cool, dry location, indoors.
To avoid dust and cobweb buildup, which can effect stove
performance, store the stove in a sealed bag or container.
Maintenance:
1. Flame Check (Every use):
The height of the flame should increase from low to high with
counter-clockwise rotation of the control knobs. Flame should be
blue with minimal yellow tipping. If flame abnormalities are found,
refer to Troubleshooting Section.
2. Disassembly (Before cleaning, or as needed):
• Turn stove off. Allow stove to cool before cleaning.
• Pinch tabs of Cooking Grate (6.1) together to release from Drip Tray
(6.2) and Chassis (6.3).
• Lift up this end of Grate, and pull Tab (Fig. 7) from under Drip Tray
and Chassis. Set Grate aside.
• Un-screw Burner (Fig. 8) by rotating counter-clockwise, taking caution
not to bend the ignitor electrode (3.3). Drip Tray (Fig. 9) is now free to
remove from Chassis.
3. Cleaning Grate / Drip Tray / 5L Flux Pot / 10” Fry Pan
(Before storage, or as needed):
Do not use a dishwasher or abrasive compounds to clean.
Only wash by hand with soapy water.
STORAGE AND
MAINTENANCE
NOTICE