9 10
• Keep burner at arm’s length, away from face, during ignition.
Flame can erupt and flare during ignition.
• Do not attempt to light with included pot or any other cookware
on the burner. Gas build-up can occur, resulting in increased
flame eruption.
• Never expose stove to flammable vapors or liquids while lighting
the burner. It can cause an explosion or fire.
• Do not move, lift, or tilt stove with lit burner. Product damage
or injury can occur due to flaring.
• Always check that the burner is extinguished before disconnecting
the fuel source. Vapors can ignite and cause serious injury.
WARNING
Lighting the Burners:
Ensure Cooking Grate is free of any cookware prior
to lighting. Gas build-up can occur, resulting in
increased flame eruption.
1. Open control valve (3.1) counterclockwise until fully opened and
gas flow can be heard.
NOTE: Our advanced Simmer Control technology requires 4 complete
rotations to achieve full gas flow.
2. To light, flip the Igniter Lever (3.2) as shown in Fig. 3.
Repeat as necessary.
3. If ignition does not occur within 5 seconds, close control valve (3.1) and
wait 5 minutes before repeating the procedure.
Cooking:
1. Rotate control valve (3.1) of the lit burner clockwise to decrease
flame setting.
2. Ensure cookware is centered on the cooking grate.
Expanding your cooking system:
• This stove comes equipped with a Patented JetLink™
fuel output port (3.4), which provides regulated fuel to
additional JetLink™-compatible stoves and accessories
offered by Eureka! or Jetboil.
• The port is located on the right side of the Stove.
• Refer to instructions accompanying JetLink™ accessories
for their use.
Do not attempt to use stoves or accessories that are not
certified as JetLink™-compatible by Eureka! or Jetboil.
Operating Instructions are continued on page 11.
OPERATING
INSTRUCTIONS
CAUTION
WARNING
To Next Page
Loading...
