24
Note:
1. The handset buttons need to be held for 1 to 2 seconds for the signal to activate the fire.
2. When the battery power is becoming low a beeping sound will continue every time you
use the fire, please contact your supplier to arrange for a new Lithium battery pack.
Cleaning instructions
IMPORTANT -
TURN OFF THE FIRE AND ALLOW IT TO COOL BEFORE COMMENCING CLEANING.
To maintain the finish on Decorative Trims.
The high quality finish needs careful handling to avoid scratching.
There is no lacquer on the burnishing, satin steel or brass since the heat of the fire will discolour it.
Day to day cleaning can be carried out by wiping with a soft damp cloth.
However, as with any natural metal, tarnishing will occur and this should be kept bright using a non–
abrasive metal polish applied with a soft cloth. Always polish with the grain of the material. Some
trims have a textured surface. Marks on a textured surface can be removed with a small soft bristled
brush. Take care not to scratch the finish.
Any finger marks should be polished out as these will cause tarnishing if left.
Cleaning the fuel bed
Note: Due to the fibre material used in the fuel bed it is inevitable that cleaning/replacement can be
a dirty and dusty operation. Suitable precautions should be taken.
1. Turn off the fire and allow to cool.
2. Carefully remove all the coals by hand and remove any soot deposits with a soft brush.
Do not wash the coals as this will cause damage. Do not use a vacuum cleaner.
3. Carefully replace the coals as described in ‘coal lay’.
IMPORTANT
Do not use the fire with broken or missing loose coals, rear, front or side coal beds.
Never add any extra coals above the number stated in these instructions. This could cause a safety
hazard. Only the fuel bed parts supplied with the appliance or authorised Jetmaster replacements
must be used.
High Low
Pilot Only
Off
Ignition—To light fire, push both buttons at same time
Fig 16
To Next Page
Loading...
Need help?
General
