1.3 Unfolding the Element Pro
Connect
Screws
1.4 Operating the Element Pro
LCD
Display
Speedometer
Speed Mode
Make sure the Release Lever and
Handlebars are secure. Unlock
the Release Lever to fold.
Lock the Release Lever by lifting
it up until it clicks.
Release Lever
• Powering On - Press the Power Button to turn on.
• Powering Off - Hold the Power Button for 2 seconds to turn off.
• Speedometer - Hold the Power Button for 6 seconds to switch
between mph and km/h.
• Speed Modes - Press the Power Button once to switch the speed modes.
• Light Function - Press the Power Button twice to turn on the headlight.
The light symbol will show on the LCD Display.
1 - Max speed
up to 10 mph
2 - Max speed
up to 13 mph
3 - Max speed
up to 15.5 mph
Lights
0-20% 20-35% 35-50% 50-65% 65-80% 80-100%
1
(Solid Light)
1
(Flashing Light)
2 3 4 5
Percentage
BATTERY LEVELS
SPEED SETTINGS:
Battery
Indicator
Bolt
Small Screw
If the Release Lever becomes loose:
• Loosen the Small Screw with a 2 mm Hex Key.
• Use a flathead screwdriver to tighten and lower the Bolt.
• Press the Release Lever against Stem until it locks.
• Tighten the Small Screw.
*Adults must assist children in the initial assembly and adjustment procedures
to fold/unfold product and adjust handlebar to height.
To Next Page
Loading...
Need help?
General
