Jetson ESBT-V5 User Manual

Beginner/Intermediate/Advanced
There are three mode settings that can be selected in the Ride Ready app settings:
Beginner, Intermediate, and Advanced. You can also change the sensitivity of your V5
between Beginner and Advanced by pressing the power button twice when turning it on.
(Each beep signals a change in sensitivity.) Your device is preset to intermediate.
• Maximum speed in Beginner operating mode: Up to 5 mph **
• Maximum speed in Intermediate operating mode: Up to 7 mph **
• Maximum speed in Advanced operating mode: Up to 10 mph **
**There are a lot of factors, which can aect speed and drive distance, such as the weight
of the driver, weather conditions, terrain, and overall maintenance of the Jetson V5.
Bluetooth
®
Function
Your Jetson V5 is equipped with two Bluetooth
®
:
one for the APP, and one for your Bluetooth
®
speaker. You will need to connect them separately.
To connect to your Bluetooth
®®
speaker:
1. Turn on the Jetson V5 and it will become
discoverable on your device.
2. To connect, activate your Bluetooth
®
device
in your settings.
3. Connect to “music” and you will be connected (the default password is: 000000)
4. Play your music, or use the app to control more features!
Recalibrating
When the Jetson V5 experiences an error, the running indicator light will remain red,
meaning your Jetson V5 will not operate until it is properly recalibrated. To recalibrate,
follow these steps:
1. Please place your device on a at, level surface (this is crucial) with the pedals facing up.
2. Press and hold the power button until the lights on the Jetson V5 ash, and you are
notied of a successful calibration
3. Turn o the device and restart the Jetson V5 to complete the recalibration.
Charging the Battery
Your package comes with a built-in, rechargeable lithium battery pack. Before you ride,
you must fully charge the battery with the included UL-certied charger. Always use the
provided charger on your Jetson V5. Be sure to charge the battery in a clean, dry location.
1. Plug one end of the power cord into the Jetson V5, and the other into a grounded AC
outlet. The red charging light on the charger unit will turn on.
2. The charger may take up to 2 hours to complete its charge. The red light on the charger
will turn green once it is nished. Recharge the Jetson V5 after each use.
4
Your Jetson V5 is equipped with two Bluetooth
®
:
speaker. You will need to connect them separately.

Jetson ESBT-V5 Specifications

General

Brand	Jetson
Model	ESBT-V5
Category	Scooter
Language	English