*Adults must assist children in the initial adjustment procedures of the product.
1. Get Started
1.1 Charging the Battery
1.2 Indicator Lights
1.3 How to Recalibrate
• Only use the included charger
• Plug the charger into the wall before the Charging Port
• Don’t turn on the Flash while it’s charging
• Charge the battery until it is fully charged - up to 3 hours
• Replace the cover over the Charging Port when done
- Charging
- Charge Complete
< 20% 20-49% 50% +Percentage
Warning: The Flash will automatically turn off once the battery power
goes below 10% as a safety precaution.
Status Indicator Light - If the Status Indicator Light turns red or if you
are having issues with the Flash, you may need to recalibrate it.
Follow these 3 simple steps...
1. Place the Flash on a flat, level surface.
2. Hold the Power Button (for about 5 seconds) until you are notified
of a successful recalibration.
3. Restart the Flash by turning it off and then on.
Hold for 5 seconds
Indicator Light
Battery
Indicator Light
Battery
Indicator Light
Status
Indicator Light
To Next Page
Loading...
Need help?
General
