Jetson JBEAM User Manual

12
HOW TO ATTACH AUXILIARY WHEELS
Your Jetson Beam comes with auxiliary wheels you can attach, which provide a
more practical and comfortable way of carrying your Beam. To attach:
1. Lay your Beam on its side, and locate 4 screws (2 on each side) that are
towards the front wheel, close to the bottom of the deck.
2. Unscrew the 4 screws.
3. Line up the holes on the platform attached to the auxiliary wheels, with the
holes on the Beam where the screws were. Make sure the auxiliary wheels are
closest to the front end of your Beam.
4. Place a screw in each hole and tighten to secure the auxiliary wheels to your
Beam.
Once properly attached, you can use the auxiliary wheels to roll your
Jetson Beam when it’s not in use. Simply fold up the Beam and lift it up by
the handlebar (in a position where the wheels are on the bottom and the
handlebar is on top), with the auxiliary wheels being the only wheels that
should be touching the ground. Pull it behind you for easy transporting. Adjust
the handlebar to a height that’s comfortable for you.
Screws

Jetson JBEAM Specifications

General

Brand	Jetson
Model	JBEAM
Category	Scooter
Language	English