Jetson Jupiter Jumbo - Assembly

12
1.2 Assembly
NUTBOLT
1. USING THE SCREWDRIVER TIP OF THE 2BIT TOOL, REMOVE THE PREATTACHED BOLT AND NUT FROM THE HANDLEBAR BASE.
2. SLIDE THE HANDLEBAR ONTO THE SCOOTER STEM.
3. PUSH DOWN UNTIL THE PREDRILLED HOLES IN THE HANDLEBAR EACH ALIGN WITH A PREDRILLED HOLE ON
ONE SIDE OF THE STEM.
4. INSERT THE BOLT THROUGH THE HOLE ON THE SIDE OF THE HANDLEBAR ON WHICH YOUR RIGHT HAND WILL GO
WHEN RIDING.
5. TWIST THE NUT ONTO THE END OF BOLT AND TIGHTEN THE BOLT USING THE SCREWDRIVER END OF THE 2BIT TOOL.