Jetson Light Rider 20 - Page 42

40
BATTERIES FOR TIRE VALVE LIGHTS (SOME MODELS)
EACH VALVE LIGHT REQUIRES 3 AG10 1.5V BATTERIES INCLUDED.
PRIOR TO FIRST USE, A PROTECTIVE PACKAGING PIECE MUST BE REMOVED FROM INSIDE THE BATTERY COMPARTMENT.
1. REMOVE THE VALVE CONNECTOR FROM THE LIGHT SECTION BY FINGERTWISTING IT OFF COUNTERCLOCKWISE.
2. BEFORE FIRST USE: REMOVE ALL THREE BATTERIES FROM LIGHT AND SET THEM ASIDE. REMOVE AND DISCARD THE
PAPER DISC IN BETWEEN THE BATTERIES AND THE SPRING.
3. REINSERT THE BATTERIES SUCH THAT THE "+" SIDE ON EACH IS FACING THE VALVE CONNECTOR AND THE "" SIDE IS
FACING THE SPRING. REPEAT WITH THE OTHER TWO BATTERIES.
4. FINGERTWIST THE LIGHT SECTION CLOCKWISE ONTO THE VALVE CONNECTOR SECTION.
5. REPEAT STEPS 1  4 WITH THE OTHER VALVE LIGHTS.
PAPER DISCLIGHT VALVE CONNECTOR
THREE BATTERIES
1.
4.