5.4.6 Re- log on this setting interface after the Web server reset, and check the network connection status
of the module on “System” interface.
Notice:
1. After network setting is completed, the Wireless STA mode should be enabled and relative
information of your router will display on the interface automatically as follows:
Router SSID: the SSID of your router.
Signal Strength：*% （please refresh the page if it shows “0”）
IP address：192.168.1.***（Please refresh the page if it shows 0.0.0.0）
Mac address：the Mac address of your local network
2. Network setting might be failed if it still shows 0 or 0.0.0.0 in the signal strength and IP address
column. Please try to reconfigure the network connection to the device from step (a) on page 6.
Picture 17
To Next Page
Loading...