-5-
IMPORTANT NOTE: TRANSPORTING YOUR JIFFY
ICE DRILL
When transporting your Jiffy Ice Drill on an ATV or
snowmobile, it is extremely important to follow
these instructions and use caution to avoid
damage to the power head (engine and
transmission) or related equipment:
There are many after-market ice drill carrier
mounting systems to choose from. Make sure the
carrier system you purchase or use has the proper
support for the power head. Many systems are
designed to only support and mount to the lower
drill assembly. This leaves the power head
unsupported. This situation will result in major
damage to the engine and transmission. Take the
necessary steps insure proper support of the
power head as noted above. If the power head is
not properly supported during transportation, this
will void the limited warranty and all repairs or
replacement costs will be the responsibility of the
owner. Purchase the correct carrier mounting
system and exercise extreme caution when
transporting the auger.
NOTE: To further protect your power head when
transporting, make sure the power head is covered
to minimize any snow or ice build-up or
accumulation on any of the functional engine
parts, such as the carburetor, throttle, or throttle
cable assemblies. Jiffy has an accessory power
head cover (Jiffy #4022) to protect the power head
from these types of conditions and can be
purchased at most retail locations.
To Next Page
Loading...
