JingYan TLL90S - Modbus Register Control; Registers for Writing Data; Output Port Configuration; Selecting Output Communication Port

2022 Aug 15
21
0x006B
Low 16 bit
complement 0001= 000.1 Degree
0x006C
High 16 bit
Sensor’s temperature 00001=000.01
degree Celsius
0x006D
Low 16 bit
Register to Write
Address
Purpose (16 bit data)
0x12C
Measuring
Mode
0
Tilt angle reading mode
1
Gyro measuring mode
0x12D
Measuring
Format
0
Degree
1
mm/M
2
Gradient (Slope)
ADDRESS: 1-255 is TLL90S Modbus device address, selection by “ZERO” and “ HOLD”
button and then press “SET” to confirm
BUAD RATE: 9600, 19200, 38400, 56000, 57600, 115200bps selection by “Up” and
“ Down” button and then press “Set” to confirm. Need power reset to active new buadrate.
Choose the output port
1. Press and hold “Angle/Set” key and enter MENU mode
2. Select “COMMUNICATION” by “ZERO” and “HOLD” key, press “SET” key to
enter Data communication
3. Scroll “USB” or “RS485” by “Zero” and “HOLD” key