JingYan TLL90S - Communication Settings Configuration; Setting TX Transmission Mode; Configuring Device Address; Setting Communication Baud Rate

2022 Aug 15
22
4. Press “SET” key to confirm which port to communicate
Set the TX mode
1. Press and hold “Angle/Set” key and enter MENU mode
2. Select “COMMUNICATION” by “ZERO” and “HOLD” key, press “SET” key to
enter Data communication
3. Set the transmission mode AUTO or REPLY mode
4. Press “SET” key to confirm
Set the address
1. Press and hold “Angle/Set” key and enter MENU mode
2. Select “COMMUNICATION” by “ZERO” and “HOLD” key, press “SET” key to
enter Data communication
3. Set the device address by “Zero” and “HOLD” key
4. Press “SET” key to confirm
Set the BAUD RATE
1. Press and hold “Angle/Set” key and enter MENU mode
2. Select “COMMUNICATION” by “ZERO” and “HOLD” key, press “SET” key to
enter Data communication
3. Set the baud rate by “Zero” and “HOLD” key
4. Press “SET” key to confirm