JJC JF-U1 User Manual

Wireless Flash Trigger:
1. Turn OFF the power of camera and receiver.
2. Mount the transmitter to the camera hot shoe socket.
3. Mount the flash on the receiver hot shoe socket.
4. If your flash or studio light does not have a hot shoe, connect the studio light cable
to the flash or studio light to the ACC2 socket of the receiver.
5. Set the channel selector at same position on both the transmitter and the receiver.
When using multiple flash units, make sure set all receivers to the same channel.
6. Shift the Mode switch to the Flash option.
7. Press the test button on the transmitter.
8. If the transmitter and the receiver status lights are turning red and your flash trigger
all of the settings are correct.
Wired Shutter Release:
Note: To use this function , you need to purchase a JJC shutter release cable to fit
your camera.
1. Turn OFF the power of camera.
2. Connect the shutter release cable to the ACC1 socket of transmitter and remote
socket of camera body.
3. Turn ON the power of camera.
4. Press the test button on the transmitter.
5. Half press for focus and full press for shutter release.

JJC JF-U1 Specifications

General

Brand	JJC
Model	JF-U1
Category	Remote Control
Language	English