STEP 9: Align the two holes in the Driver Bracket with the two threaded inserts in the back of the enclosure. Slide a 3/8″ Split Lock
Washer and a 3/8″ Flat Washer over each of two 3/8 – 16 x 1-1/2″ Hex Head Bolts, thread an assembly through each hole in the
Driver Bracket, into a threaded insert, and hand tighten. Repeat the process for the Passenger Bracket on the other end of the
enclosure.
STEP 10: Carefully place the Stealthbox® into the vehicle, and align the slots in the Driver Bracket and Passenger Bracket with the
factory seat bracket holes. Center the enclosure in the vehicle. Using an E14 Torx socket and wrench, fully tighten the two factory
seat bracket bolts. Using a 9/16″ socket and wrench, fully tighten the four 3/8 16 x 1-1/2″ Hex Head Bolts.
S T E P 11: Connect speaker cable to the terminal cup on the back of the enclosure, and route the cable as necessary.
Reinstall the hardtop hardware storage box.
To Next Page
Loading...
Need help?
General
