ADC D30 DRYER
Installation Specification - Dimensions shown in millimetres
Model D30
Dimensions (HxWxD) Gas/Steam 1835 x 870 x 765mm
Electric 1910 x 870 x 765mm
Boxed 1960 x 910 x 780mm
Nett weight Gas/Electric 185kg (407lb)
Steam 197kg (433lb)
Water Connection
No of inlet valves 1 cold
Minimum pressure 1.4 bar (20 psi) (max 60psi)
Inlet size
3
/4” BSP via 15mm supply
Flow rate 20 litres/min
Electrical
Standard Gas or Steam 240v/50Hz/1ph/13A
Reversing motor model 415v/50Hz/3ph+N/10A/ph (optional)
Electric 415v/50Hz/3ph+N/32A/ph - 18kw
Motor rating 373 watt
Gas
Heat input 23kw (78,000Btu)
Supply P
ressure Natural gas 15mb(6”wc) min - 30mb (12”wc) max - above 30mb a regulator must be fitted.
Burner Pressure Natural gas 8.7mb(3.5”wc)
Supply Pressure LPG Propane 37mb(14.8”wc) Butane 28mb(11.2”wc)
Inlet size
1
/2”
BSP male via a
1
/2”
flexible armoured hose
Exhaust & Ventilation - Recommended Guides
Exhaust outlet size 200mm (8”) dia
Total max. length Horizontal 25.9m (85ft) This allows for the use of 1 No 90 degree bend
V
ertical
16.7m (55ft) This allows for the use of 1 No 90 and 1 No 180 bend
Max permissible exhaust back pressure 0.74mb (0.3”wc)
Airflow Gas/Electric/Steam 10.93m
3
(386ft
3
)/min
Free air intake requirement 0.05m
2
(78in
2
)
Steam
Consumption
45kg/hr (100lb/hr) @ 125 psi
Operating Pressure 7kg/cm
3
(100psi) - 8.8kg/cm
3
(125psi)
Connection - supply/return
1” BSP/
1
/2” BSP
Compressed air (Steam model ONL
Y)
Consumption 0.02m
3
/hr (0.75ft
3
/hr)
Pressure 80psi
Connection
1
/8” BSP
Minimum installation distance - Rear 400mm
I/D30/09/04
A - Electrical connection, B - Gas Inlet, C - Steam Inlet, D - Steam return, E - Exhaust outlet, F - Steam dryer operating height,
G - Water Inlet (S.A.F.E. Sensor Activated Fire Extinguishing system), H - Compressed air connection (Steam only)
To Next Page
Need help?
General
