To Next PageTo Next Page
Need help?Do you have a question about the JLA D120 and is the answer not in the manual?
Defines where the dryer must be installed according to local codes, ordinances, and safety standards.
Instructions for removing shipping materials and preparing the dryer for its final placement.
Specifies clearances required around the dryer for safety, maintenance, and proper operation.
Details the necessity of adequate ventilation and make-up air for optimal dryer performance.
Guidelines for designing and installing exhaust ducts to ensure proper airflow and prevent hazards.
Methods to protect exterior exhaust openings from weather and obstructions for optimal function.
Recommendations for routing exhaust from individual dryers directly outdoors with minimal turns.
Outlines responsibilities for safe electrical connections by licensed professionals according to codes.
Details voltage, phase, and circuit breaker requirements for gas and steam dryer models.
Explains how to make power and ground connections to the dryer's terminal block safely.
Stresses the importance of proper grounding for personal safety and controller operation.
Covers requirements for gas type, piping, pressure, and professional installation for gas dryers.
Details manifold pressure and in-line pressure requirements for natural gas and L.P. gas.
Specifies inlet connections, pipe sizes, and installation standards for gas supply lines.
Specifies the required pH range for steam coils to prevent damage and ensure longevity.
Outlines supply/return line connections and operating pressure for high-pressure steam systems.
Explains the function of the pneumatic damper system and its airflow control for heating/cooling.
Lists essential checks before attempting to operate the dryer for the first time.
Recommends a test run after installation to ensure proper function and user instruction.
Describes how to test the ignition and heat system for gas models after initial start-up.
Details the computer controller, spin times, and program selections for dryer operation.
Specifies the external compressed air supply needed for steam dampers and air jets.
Notes that external regulation and filtration are required for the compressed air supply.
Procedures for safely taking the dryer out of service for a period, including power and supply shutoff.
Guidance on obtaining service and ordering replacement parts from distributors or JLA.
Instructions for completing and returning warranty cards and obtaining warranty coverage.
Emphasizes periodic inspection and cleaning of lint for efficient, safe, and trouble-free operation.
Details periodic checks and tightening of bolts, connections, safety devices, and belts.
Specifies the type of grease and frequency for lubricating drive and idler shaft bearings.
Explains how to reset the burner hi-limit thermostat for Phase 7 and Dual Timer models.
Explains the meaning of various fields on the dryer's standard and CE data labels.
Outlines tests for ignition circuit components like DSI and HSI modules.
Describes how the microprocessor controller monitors circuits and displays fault messages via LEDs.
Covers requirements for water connections, pressure, and local codes.
Explains the installation of an optional manual bypass for the S.A.F.E. system water supply.
Details how the fire extinguishing system detects high temperatures and injects water.
General
