To Next PageTo Next Page
Need help?Do you have a question about the JLA D40 and is the answer not in the manual?
Steps to follow if a gas leak is detected, including immediate actions and contacting authorities.
Warnings about flammable vapors, improper grounding, and disabling safety circuits.
Detailed physical and performance specifications including capacity, volume, and airflow.
Specifications for gas inlet, electrical voltage, heat input, and steam connections.
Instructions for removing packaging and preparing the dryer for placement.
Guidelines for proper dryer placement, floor leveling, and environmental considerations.
Specifications for clearances and materials for dryer enclosures.
Details on necessary air intake for proper dryer operation and combustion.
Guidelines for proper installation and sizing of exhaust ductwork for safety and efficiency.
Specific venting requirements for individual dryer installations.
Maximum length and elbow considerations for horizontal exhaust duct runs.
Maximum length and elbow considerations for vertical exhaust duct runs.
Guidelines for common horizontal exhaust ducting for multiple dryers.
Guidelines for common vertical exhaust ducting for multiple dryers.
Standards and precautions for electrical installation by qualified personnel.
Electrical service specifications for gas and steam dryer models.
Electrical service specifications for all-electric dryer models.
Procedures for proper electrical connections and grounding methods.
Wiring hookup details for single-phase gas and steam dryers.
Wiring hookup details for three-phase gas and steam dryers.
Requirements and standards for connecting the gas supply to the dryer.
Manifold and in-line pressure specifications for natural and propane gas.
Guidelines for steam coil pH levels and operating pressure for optimal performance.
Instructions for proper installation of steam supply and return lines.
Recommended air pressure ranges for the pneumatic damper system.
Information on air connection and the need for external regulation and filtration.
Explanation of the steam damper's function in heating and cool down modes.
Specifications for water supply pipe size, pressure, and flexible hose connections.
Details on the water solenoid valve and optional manual bypass installation.
Essential checks before operating the dryer, covering labels, voltage, gas type, and components.
Initial start-up procedures and ignition system checks for gas dryers.
Functional checks of safety circuits like door switches, hi-limits, and sail switches.
Instructions for cleaning the protective coating from the dryer basket.
Steps for operating coin-operated dryers using the microprocessor controller.
Procedures for using mechanical coin meters or slide coin meters.
Operating instructions for non-coin dryer models using LED displays.
Instructions for operating dual timer dryers and adjusting spin/dwell times.
Guidelines for qualified service technicians and contacting the reseller.
Information on how to purchase replacement parts from the reseller or manufacturer.
Instructions for completing and returning warranty cards for record-keeping.
Schedule and methods for cleaning lint screens, lint chambers, and exhaust systems.
Regular checks of bolts, connections, controls, and safety devices.
Information on lubricating motor and tumbler bearings, though often permanently lubricated.
Steps for removing and cleaning the lint drawer.
Explanation of the information found on the dryer's data label for service and parts.
Steps to verify the functionality of the replacement microprocessor controller board.
Theory of operation and diagnostic indicators for the DSI controller.
How to reset the burner hi-limit thermostat for Phase 7 models.
Procedure for resetting the burner hi-limit thermostat on dual timer models.
General
