113375-16 Telephone 01422 822282 19
Air Connection
Air connection to this system is a 1/4” quick connection as per
the illustration below.
Warranty Information ____________
Returning Warranty Cards
Before any dryer leaves the factory test area, a
warranty card is placed on the back side of the main
door glass. These warranty cards are intended to serve
the customer where we record the individual installation
date and warranty information to better serve you,
should you file a warranty claim.
If a warranty card did not come with your dryer, contact
the JLA Warranty Department.
IMPORTANT: A separate warranty card must be
completed and returned for each individual dryer.
NOTE:
Be sure to include the installation date when
returning the warranty card(s).
Warranty
For a copy of the JLA commercial warranty covering
your particular dryer(s), contact the distributor from
whom you purchased the equipment and request a
dryer warranty form. If the distributor cannot be
contacted or is unknown, warranty information can be
obtained from JLA by contacting the JLA Warranty
Department.
NOTE:
Whenever contacting the JLA factory for
warranty information, be sure to have the dryer’s
model number and serial number available so that
your inquiry can be handled in an expeditious
manner.
Routine Maintenance _____________
A program and/or schedule should be established for
periodic inspection, cleaning, and removal of lint from
various areas of the dryer, as well as throughout the
ductwork system. The frequency of cleaning can best
be determined from experience at each location.
Maximum operating efficiency is dependent upon
proper air circulation. The accumulation of lint can
restrict this airflow. If the guidelines in this section are
met, a JLA dryer will provide many years of efficient,
trouble free, and most importantly, safe operation.
!
WARNING
Lint from most fabrics is highly combustible.
The accumulation of lint can create a potential
fire hazard.
Keep dryer area clear and free from
combustible materials, gasoline, and other
flammable vapors and liquids.
NOTE:
Remove power from the dryer before
performing any maintenance in the dryer.
Suggested time intervals shown are for average
usage which is considered six to eight operational
(running) hours per day.
IMPORTANT: The dryer produces combustible lint
and must be exhausted to the outdoors. Every 6
months, inspect the exhaust ducting and remove any
lint build up.
Shutdown Instructions __________________
If the dryer is to be shut down (taken out of service) for a period of
time, the following must be performed:
Discontinue power to the dryer either at the external disconnect
switch or the circuit breaker.
Discontinue the heat supply:
GAS MODELS … discontinue the gas supply.
SHUT OFF external gas supply shutoff valve.
STEAM MODELS … discontinue the steam supply.
SHUT OFF external (location furnished) shutoff valve.
Service / Parts Information ______________
Service
Service must be performed by a qualified trained technician,
service agency, or gas supplier. If service is required, contact
the distributor from whom the JLA equipment was purchased. If
the distributor cannot be contacted or is unknown, contact the
JLA Service Department for a distributor in your area.
NOTE:
When contacting the JLA Service Department, be sure
to give them the correct model number and serial number so
that your inquiry is handled in an expeditious manner.
Parts
Replacement parts should be purchased from the distributor from
whom the JLA equipment was purchased. If the distributor cannot
be contacted or is unknown, contact the JLA Parts Department
for a distributor in your area. Parts may also be purchased directly
from the factory by calling the JLA Parts Department at 01422
822282 or you may FAX in your order at 01422 824390.
NOTE:
When ordering replacement parts from the distributor or
JLA be sure to give them the correct model number and serial
number so that your parts order can be processed in an
expeditious manner.
To Next Page
Loading...
