system.
应避免暴晒，雨淋，水滴，避免长期置于高温，高湿的环境中。
Avoid sun, rain, water drops, avoid long-term under high temperature, high humidity environment.
在使用过程中，应远离热源，高压；切勿重击，更不能投入火中或水中。
During use, stay away from heat, high voltage;Don’t blow, don’t drop into fire or water.
当音乐音量变小或失真，迟缓，无声时，可能说明锂电池电量不足，需要进行充电。
When volume become smaller, distortion, slowly, quiet, may indicate low power, need to charge.
可使用 Micro USB 充电线与电脑 USB 接口连接或使用 DC4.5V-DC5V/500mA-1A 充电器充
电或作为外部电源使用。
Use Micro USB charging cable connect with PC USB port or use DC4.5V-DC5V/500mA-1A
charger to charge or use as external power supply.
当 USB 电源输入进入充电或是外部电源使用状态时，红色充电指示灯点亮。当锂电池充满
后，红色充电指示灯熄灭。
When USB power input to charge or the status of external power supply, red led indicator is
on.When fully charged, red led indicator off.
如果电池更换不当会有爆炸危险，只能用同样类型或等效的电池来更换。
If replace the battery in wrong way, explosion may happen;please use the same type of batter or
equivalent to replace.
电池不得暴露在诸如日照，火烤或类似过热环境。
Battery may not be exposed to such as sunlight, fire or similar hot environment
FCC Statement
z Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
z This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
z -- Reorient or relocate the receiving antenna.
z -- Increase the separation between the equipment and receiver.
To Next Page
Loading...
