JLL IC300 Instruction Guide

9
TROUBLESHOOT
Issue Resolutions
No power to the monitor • Make sure the batteries are fully inserted
and the correct way round.
• Check your connection wires from the
monitor to the base. They must not be
trapped, fully connected and the pins
must be straight.
Power but no readings • Check the small black sensor that is
inserted into the rear side of the casing.
If this is not inserted far enough it won’t
be able to read anything.
• However, do not push this sensor in too
far as it will catch on the chain.
No pulse reading • Make sure the pulse plates are clean and
dry.
• Do not have any lotion on your hands.
• Sweat can affect the reading.
• Make sure both hands are fully gripping
each plate.

JLL IC300 Specifications

General

Screen Size	27 inches
Resolution	1920 x 1080 (Full HD)
Refresh Rate	75Hz
Brightness	250 cd/m²
Viewing Angle	178° (H) / 178° (V)
Ports	HDMI, VGA, Audio Out
Power Consumption	25W (typical)