To Next PageTo Next Page
Need help?Do you have a question about the JMA VIENNA SMART and is the answer not in the manual?
General| Category | Cutter |
|---|---|
| Brand | JMA |
| Model | VIENNA SMART |
| Handle Material | Plastic |
| Color | Black |
Overview of the machine's design and compliance with EU safety standards.
Details on how the machine is packaged and transported safely.
Information found on the machine's identification label, including serial number and manufacturer details.
Identifies the different parts of a key that are relevant to the machine's operation.
Lists and describes the primary components and parts of the VIENNA SMART machine.
Provides essential technical specifications, such as motor power, dimensions, and weight.
Lists and describes the various accessories included with or used by the machine.
Details the main electrical circuit and its electronic components.
Explains the function and use of the machine's four-sided clamp for holding keys.
Step-by-step guide for correctly adjusting the cutting depth of the machine.
Procedures for adjusting the machine's lateral positioning for accurate key cutting.
Specific method for cutting keys that have narrow blades.
Guidance on cutting keys that do not have a shoulder stop.
Instructions for duplicating cross-shaped keys.
Step-by-step process for replacing the brush on the machine.
Detailed instructions on how to replace the cutting tool (cutter).
Guide on how to replace the tracer or stylus used for copying keys.
How to set the maximum travel depth for the machine's slide.
Instructions for checking and replacing the machine's fuses.
Procedure for replacing the main power switch and the brush activation button.
Steps for replacing or adjusting the drive belt of the machine.
Detailed guide on how to replace the machine's motor.
Instructions for replacing the capacitor associated with the motor.
How to adjust the tension of the machine's carriage.
Steps for replacing the micro switch components.
Guidelines for the proper disposal and recycling of the machine's packaging.
Instructions for the disposal of metal shavings (swarf) generated during operation.
Procedures for decommissioning and disposing of the machine itself.
