JML Instant Heater - Replacing the Remote Control Battery; Cleaning and Maintenance

CLEANING AND MAINTENANCE
• Always disconnect the heater from the power supply and allow it to cool before
attempting any maintenance.
• If the heater has collected dust or dirt inside the unit or around the heating element,
DO NOT operate the heater in this condition. Always have the unit cleaned by a
qualied service agent.
• The only maintenance required by the owner is cleaning of the external surfaces.
•
Use a damp cloth to wipe the outside of the heater. DO NOT use powerful abrasive
or solvent cleaning uids when cleaning the heater as they may damage the
plastic parts.
• If the heater is to be removed from its mounting position when not in use, always
store it carefully in a safe, dry, childproof location.
• Do not touch the heating element with bare ngers, as residue from your hand
could aect the life of the lamp. If the lamp is accidentally touched, remove
the nger marks with a so cloth moistened with methylated spirit or alcohol.
Always allow the methylated spirit or alcohol to completely evaporate before
using the heater.
• Do not attempt to repair or adjust any electrical or mechanical functions on
the heater.
• The heater contains no user-serviceable parts. Should the product suer damage
or breakdown, it must be returned to the manufacturer or its service agent.
• Damaged power cords are to be replaced by the manufacturer, service agent
or similarly qualied person.
RECYCLING
At the end of the product’s useful life it should not be disposed of with household
waste. Please check with your local authority or recycling advice in your country.
Always recycle where facilities exist.
REPLACING THE REMOTE CONTROL BATTERY
• Press the battery compartment release button and then slide out the battery tray.
• Remove the old battery and put the new battery in, making sure that the battery’s
positive side is facing up. Use only a CR2025 or CR2032 battery in this remote control.
• Slide the battery tray back into the remote control until it clicks.
Note:
Do not allow water or liquid to get into the remote control.