jobmate JMBMS210G - User Manual

Questions and Answers

J
jacksontroyAug 2, 2025
Why does my jobmate JMBMS210G Saw motor will not run?
- C
  catherinegeorgeAug 2, 2025
  There are several reasons why the motor of your Jobmate Saw might not be running: * The switch may be in the OFF position. Ensure the saw is plugged in and the switch is pressed. * There may be no electrical power at the wall outlet. Check the circuit breaker or fuse at the electrical panel. * The switch might be broken and need replacement. * The motor might be broken and need replacing. * The cable might be defective and need replacement.
M
margaret85Aug 13, 2025
What to do if my jobmate Saw blows a fuse or trips the circuit breaker repeatedly?
- P
  Patricia McgeeAug 13, 2025
  If your Jobmate Saw is causing the fuse to blow or the circuit breaker to trip repeatedly, it could be due to: * An overloaded circuit. Try disconnecting other electrical appliances from the circuit or operating the saw on its own dedicated circuit. * Using the wrong gauge wire or an extension cord that's too long. Refer to the extension cord chart for proper extension cord usage.
L
lloydshannonAug 22, 2025
How to troubleshoot a jobmate JMBMS210G Saw motor that hums but cannot run or runs slowly?
- S
  Scott DeanAug 22, 2025
  If your Jobmate Saw motor hums but cannot run or runs slowly, consider these potential causes: * Low voltage. Use a voltmeter to check the voltage at the wall outlet. * Loose electrical connections. Inspect all electrical connections to ensure they are secure. * Incorrect gauge or length of the extension cord. Check the extension cord chart for proper usage.