Jocel DW5A - E2; E3; E4

Water valve is damaged
Replace the water valve
Water valve or hose is blocked Disassemble and clean the water
valve or hose
Damaged or defective drain pump Replace the drain pump
Drain hose is obstructed or bended
Put the hose in the right way
Working switch wring is wrong connected
Repair the wiring
The floater base Is too dirty ang cause
floater is stickled
Replace or clear the floater base or
floater
E2
Defective the electric control Replace the electric control
The voltage too low Minimum voltage of 198V
Damaged the thermostat 2 or the fuse for
the heating element
Replace the thermostat 2 or the
fuse
The wring is wrong connected Repair the wiring
Thermostat 1 is Damaged Replace the thermostat 1
Damaged the heating element Replace the heating element
E3
Defective the electric controller Replace the electric controller
Water valve is damaged
Replace the water valve
The protection switch wring is wrong
connected
Repair the wiring
Working switchwring is wrong connected Repair the wiring
E4
Defective the electric control Replace the electric control
The cover of the softener is loosed Tighten the cover
`Salt leakage
(for equipped
with softener)
The o-ring of the cover is inversed Replace the o-ring
Door switch is damaged Replace door swich
Door lock is damaged Replace door lock
The wring is wrong connected Repair the wiring
Not operate
after push start
key
Defective electric control Replace electric control
Water valve is damaged Replace the water valve
Fill water not
stop
Defective electric control Replace electric control
Too less fill
water
Dishwasher not level Level the dishwasher
Door switch wring is wrong connected Repair the wiring Dishwasher
runs with door
open
Defective electric control Replace electric control
Defective motor bearings Replace motor.
Defective motor capacitor. Replace motor capacitor.
Damaged or defective wiring Repair wiring
Motor hums but
not start or run.
Improper motor voltage. Replace motor.
Improper motor voltage. Replace motor.
Motor shaft binding. Replace motor.
Defective motor capacitor. Replace motor capacitor.
Motor trips out
on internal
thermal
overload
protector
Motor windings shorted. Replace motor.
The fuse for the
heating
Defective or too dirty the inner of the
bobber base
Replace or clear the bobber base