b) Manual operation
Working mode of heater:
(1) Day mode “
”, the temperature can be set between 5 and 35℃.
(2) Night mode “
”, the temperature can be set between 5 and 35℃.
(3) Anti-freezing mode “
”, the temperature can be set between 5 and 15℃.
IMPORTANT: The temperature you select should always be above the reference temperature
reflected on the screen of heater.
The heater will not work if the programmed temperature is less than the reference
temperature indicated on the screen.
When selecting a room temperature, you should choose a few degrees more than the
desired temperature, as the temperature recognized and indicated by the screen, when it is
working, is the exact temperature beside the heater and not the room temperature. For this
reason the selection option has reference temperature up to 35
℃.
Operate the appliance follow following steps:
(1) Plug in, turn the power switch on. The screen will flash for a few seconds, and the reference
temperature beside the heater will appear on the screen. Then stand-by mode is ready.
(2) Press “
”. The heater starts working. When heater working press “ ” again, heater stop
working and turns into stand-by.
(3) Select the working mode by pressing mode button ( “
”, “ ” or “ ”). The screen will show
the symbol of the selected mode.
(4) Press “
” and “ ” to set the desired temperature for the chose working mode. While setting
the temperature, “℃” will be flashing.
(5) Once the desired temperature has been set it will disappear from screen and the new ones
which indicate the reference temperature will appear.
• Repeat (3), (4) and (5) for other mode.
• Now select the mode you want the heater to work.
• When the reference temperatures reach the set temperature the heater will stop heating
and the power indicator “
” disappear from the screen.
• When the temperature drops 3℃ the heater will start heating automatically and the power
indicator “
” will appear on the screen.
NOTE: The power indicator “
” may flash when the reference temperature is approaching the
setting temperature.
IMPORTANT: If the appliance is disconnected from the power, the power switch is turned off
or there is a power cut off, the setting temperature will be stored in the memory. Before
resetting the heater, you must unlock it either with the remote control by pressing “
”
twice, or switch off then switching on the power switch, or press both “
” and “ ” for
several minutes.
c) Programmed operation
NOTE: If you performed a manual operation and want the programmed temperature to be
the same, you do not need to modify it.
• Before this programmed operation the actual time and day must be set.
• To do his, press “
” for a dew seconds until the display shows “00:00”. The first two digits is
for the time. Press “
” or “ ” to adjust the current time then press “ ” again to remain set.
• Then the digits for minutes flash. Use the same buttons “
” or “ ” to adjust the current
minutes, and press “
” to set.
-21-
To Next Page
Loading...
