Jofemar T15 - Page 2

MNP64ENV00 Date: 03-2007 Rev. 03 Page 2 of 16
F WARNING
Read the following instructions carefully before connecting this module:
- iBefore connecting the selector to/in the vending machine, make sure that
the machine works properly and that the connector is the appropriate one for this
selector.
- Never connect or disconnect the selector if the vending machine is connected
to mains.
- Make sure that the connecting cable is reliably inserted in the selector and
in the vending machine.
- Make sure that the selector’s back cover is in place and secured and the coin
passages clean and free of any obstruction before connecting it to the vending
machine.
- Check that the connecting cable between the selector and the vending
machine is not damaged and that there is no risk of electrical contact because cables
are not properly insulated.
- iOnly clean the selector coin entry and testing area to prevent legal tender
coins from being rejected using a cloth that does not scratch the selector’s plastic
surface.
- iDo not clean the selector with abrasive or highly concentrated products or
with a water jet.
- In case of doubt, please contact Jofemar Technical Support Service.
- We recommend reading the selector manual before connecting or handling it.
Jofemar S.A.
Ctra. de Marcilla Km.2, 31350 Peralta. Navarra, Spain.
http: // www.jofemar.com Tel. +34 948 75 12 12 Fax +34 948 75 04 20