Contents
Page
Diesel Exhaust Fluid (DEF) — Use in
Selective Catalytic Reduction (SCR)
Equipped Engines ........................................ 115-7
Testing Diesel Exhaust Fluid (DEF).................. 115-7
Storing Diesel Exhaust Fluid (DEF).................. 115-8
Refilling Diesel Exhaust Fluid (DEF) Tank........ 115-9
Cleaning Diesel Exhaust Fluid (DEF) Tank .... 115-10
Disposal of Diesel Exhaust Fluid (DEF) ......... 115-10
Diesel Engine Coolant (engine with
wet sleeve cylinder liners) .......................... 115-11
John Deere COOL-GARD™ II Coolant
Extender..................................................... 115-12
Operating in Warm Temperature Climates ..... 115-12
Water Quality for Mixing with Coolant
Concentrate................................................ 115-13
Testing Coolant Freeze Point ......................... 115-14
Diesel Engine Break-In Oil —
Non-Emissions Certified and
Certified Tier 1, Tier 2, Tier 3, Stage
I, Stage II, and Stage III ............................. 115-15
John Deere Break-In Plus™ Engine Oil
— Interim Tier 4, Final Tier 4, Stage
IIIB, and Stage IV ....................................... 115-15
Diesel Engine Oil — Tier 2 and Stage II......... 115-16
Diesel Engine Oil — Tier 3 and Stage III........ 115-17
Diesel Engine Oil — Interim Tier 4,
Final Tier 4, Stage IIIB, and Stage IV......... 115-18
Diesel Engine Oil Service Interval for
Operation at High Altitude .......................... 115-18
Engine Oil and Filter Service Intervals
— Tier 2 and Stage II Engines ................... 115-19
Engine Oil and Filter Service Intervals
— Tier 3 and Stage IIIA —
PowerTech™ Plus Engines........................ 115-20
Engine Oil and Filter Service Intervals
— Interim Tier 4, Final Tier 4, Stage
IIIB, and Stage IV Engines ......................... 115-21
Oilscan™ and CoolScan™............................. 115-21
ProDrive™ Transmission,
CommandTouch™ Multi-Speed
Feeder House Drive, Hydrostatic
Drive System, Main Hydraulic
System, and Main Engine Gear
Case Oils.................................................... 115-22
Transmission (Mechanical Shift
and Push-Button Shift), Final
Drives, Loading Auger, Primary
Countershaft, and Two-Speed
Separator Drive Gear Case Oils ................ 115-23
Feeder House Reverser Gear Case............... 115-24
Grease............................................................ 115-24
Brake Fluid (If Equipped)................................ 115-24
Oil Filters ........................................................ 115-25
Fuel Filters...................................................... 115-25
Alternative and Synthetic Lubricants .............. 115-25
Lubricant Storage ........................................... 115-25
Mixing of Lubricants........................................ 115-25
Page
Lubrication and Maintenance
Service Interval—Setup or Clearing .................120-1
Lubrication Decal Locations .............................120-1
Hydraulic Hose Replacement ...........................120-1
Hydraulic System Cleanliness ..........................120-2
Accumulator Pressure ......................................120-2
Lubrication Symbols .........................................120-2
Service Your Machine at Specified Intervals ....120-2
Important Considerations .................................120-2
Maintenance—Every 10 Hours
Service Interval Chart—Every 10 Hours....... 120-A-1
Engine Oil Level ........................................... 120-A-2
Engine Coolant ............................................. 120-A-3
Rotary Screen, Oil Cooler, Condenser,
Radiator, and Charge Air Cooler .............. 120-A-3
Hydrostatic/Hydraulic Oil .............................. 120-A-5
Main Engine Gearcase Oil............................ 120-A-6
Air Compressor Reservoir (If Equipped)....... 120-A-6
Fuel Precleaner Filter ................................... 120-A-6
Two Speed Four-Wheel Drive Motor
Pivots (Muddy Conditions) ....................... 120-A-7
Two-Wheel Drive Heavy-Duty and
Extra Heavy-Duty Axle Spindle
Bearings/Pivot Pins (Muddy Conditions).. 120-A-7
Final Drive Outer Bearings (Muddy
Conditions) ............................................... 120-A-7
Air Conditioner Drain Hose........................... 120-A-8
Variable Speed Feeder House
Reverser Drive Gear Case (S760
and S770 Machines) (Severe
Conditions) ............................................... 120-A-8
Stone Trap.................................................... 120-A-8
Tailings Elevator Slip Clutch (S780 and
S790 Machines) ....................................... 120-A-9
ActiveVision™ Tailings System
Camera (If Equipped)............................... 120-A-9
Maintenance—Every 50 Hours
Service Interval Chart—Every 50 Hours....... 120-B-1
Two Speed Four-Wheel Drive Motor
Pivots (Normal Conditions) ...................... 120-B-2
Two-Wheel Drive Heavy-Duty and
Extra Heavy-Duty Axle Spindle
Bearings and Pivot Pins (Normal
Conditions) ............................................... 120-B-2
Final Drive Outer Bearings (Normal
Conditions) ............................................... 120-B-2
Variable Speed Feeder House
Reverser Drive Gear Case (S760
and S770 Machines) (Normal
Conditions) ............................................... 120-B-3
Feeder House Reverser Drive Gear
Case Oil ................................................... 120-B-3
Variable Speed Feeder House Upper
Sheaves (S760 and S770 Machines)....... 120-B-3
Continued on next page
xi
070717
PN=11
To Next Page
Loading...
