EasyManua.ls Logo

john deer S780 - Service Tires Safely

Default Icon
51 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Contents
Page
Lateral Tilt Feeder House ............................. 120-B-4
Separator Variable Speed
Driven/Driver Sheaves ............................. 120-B-4
Separator Variable Speed
Driven/Driver Sheaves (S780 and
S790 Machines) ....................................... 120-B-5
Cleaning Fan Variable Upper and
Lower Sheaves ........................................ 120-B-5
Fuel Precleaner Filter ................................... 120-B-5
Two-Speed Separator Drive Oil.................... 120-B-6
Water Separator Primary Fuel Filter ............. 120-B-6
Radiator, Charge Air Cooler, Oil Cooler,
and Condenser......................................... 120-B-7
Mass Flow Sensor ........................................ 120-B-7
Cab Fresh Air Filter ...................................... 120-B-7
ActiveVision™ Clean Grain Elevator
Camera (If Equipped)............................... 120-B-8
Maintenance—First 100 Hours
Service Interval Chart—First 100 Hours....... 120-C-1
Main Engine Gear Case Filter (S760
and S770 ProDrive™ Machines).............. 120-C-1
Main Engine Gear Case Lube Filter
(ProDrive™ Machines)............................. 120-C-1
Maintenance—Every 100 Hours
Service Interval Chart—Every 100 Hours..... 120-D-1
Tire Pressure and Bolt Torque...................... 120-D-1
Maintenance—Every 200 Hours
Service Interval Chart—Every 200 Hours..... 120-E-1
Recirculating Filter........................................ 120-E-1
Primary Countershaft (Multi-Speed
Feeder House on S770, S780, and
S790 Machines) ....................................... 120-E-2
Separator Variable Speed
Driven/Driver Sheaves (S760 and
S770 Machines) ....................................... 120-E-2
Maintenance—Every 250 Hours
Service Interval Chart—Every 250 Hours..... 120-F-1
Engine Oil and Filter (Tier 2/Stage II
and Tier 3/Stage IIIA) ............................... 120-F-2
Engine Oil and Filter (Final Tier 4/Stage IV).. 120-F-3
Fuel Tank Breather ....................................... 120-F-3
Diesel Exhaust Fluid (DEF) Tank
Breather (Final Tier 4/Stage IV) ............... 120-F-4
Maintenance—Every 400 Hours
Service Interval Chart—Every 400 Hours.....120-G-1
Fuel Precleaner Filter ...................................120-G-1
Water Separator ...........................................120-G-2
Primary and Secondary Fuel Filter...............120-G-3
Variable Speed Driver/Driven Sheaves
(Final Tier 4/Stage IV) (S760 and
S770 Machines) .......................................120-G-4
Page
Unloading Auger Upper Gear Case..............120-G-4
Header/Reel Drive Pump Sheave Bearing...120-G-5
Primary Countershaft Universal Joint
Spline (Non-Multi-Speed Feeder
House)......................................................120-G-5
Vertical Unloading Auger Upper Gear
Case (S780 and S790 Machines) ............120-G-5
Chopper/Unloading Driveshaft Bearing ........120-G-6
Variable Speed Driver Sheave .....................120-G-6
Feed Accelerator Bearings ...........................120-G-6
Service Interval Chart—Every 400
Hours (Continued)....................................120-G-7
Tailings Auger Drive Slip Clutch (S760
and S770 Machines) ................................120-G-7
Conveyor Auger Drive Slip Clutch................120-G-8
Right-Hand Side Lube Bank .........................120-G-8
Overshot Beater Bearings (Optional)
(S770, S780, and S790 Machines) ..........120-G-8
Discharge Beater Bearings...........................120-G-9
Cleaning Fan Shaft Bearings........................120-G-9
Rear Axle Tie Rod ........................................120-G-9
Spreader Disk (If Equipped) .......................120-G-10
Overshot Beater Gear Case Oil
(Optional) (S770, S780, and S790
Machines)...............................................120-G-10
Separator Drive Oil .....................................120-G-10
Final Drive Oil ............................................. 120-G-11
Service Interval Chart—Every 400
Hours (Continued)..................................120-G-12
Transmission Oil (S760 and S770
Non-ProDrive™ Machines) ....................120-G-13
Park Brake Cylinder Cables (S760
and S770 Push-Button Shift
Transmission Machines) ........................120-G-13
Final Drive Couplers ...................................120-G-13
Batteries .....................................................120-G-14
Hydraulic/Hydrostatic Filter (S760 and
S770 Machines) .....................................120-G-14
Hydrostatic Charge Filter............................120-G-15
Main Engine Gear Case Filter ....................120-G-15
Engine Debris Management Air Filter
(Final Tier 4/Stage IV Engines) ..............120-G-16
Fire Extinguishers.......................................120-G-16
Primary Countershaft Gear Case Oil
(Fixed Speed and Variable Speed
Feeder House Drive)..............................120-G-16
Brake Fluid (S760 and S770
Non-ProDrive™ Machines) ....................120-G-17
Seat Belts ...................................................120-G-17
ProDrive™/Main Engine Gear Case
Lube Filter (ProDrive™ Machines).........120-G-17
Feeder House Slip Clutch...........................120-G-18
Multi-Speed Feeder House Drive
(S770, S780, and S790 Machines) ........120-G-18
Loading Auger Gear Case Oil ....................120-G-18
Continued on next page
xii
070717
PN=12

Related product manuals