John Lewis 803/50402 User Manual

John Lewis
Small double
Pre-assembly Preparation
Please ensure instructions are read in full before attempting to assemble this product.
Necessary Tools
Please check the pack contents before attempting to assemble this product. A full checklist of
components is given in this leaflet. If any components are missing, please contact the John Lewis Helpline.
This product takes approximately
40 MINUTES to assemble with 2 PEOPLE.
The fittings pack contains
SMALL PARTS which should be KEPT AWAY FROM YOUNG
CHILDREN
.
Read this leaflet in full before commencing assembly.
If you require any additional information or have any issues with this product please call the John Lewis
Helpline on 01244 - 689949 or e-mail: mail@fwgroup-uk.com
Alpha Bedstead
This product is HEAVY. It should be assembled as near as possible to the point of use. TAKE CARE
WHEN LIFTING
to avoid personal injury and (or) damage to the product.
Keep the support legs 5mm above the ground.
Thank you for purchasing this Alpha bedstead. Please read the instructions carefully before use to
ensure safe and satisfactory operation of this product.
For product support or spare parts
please call the John Lewis Helpline;
Tel: 01244 - 689949
e-mail:mail@fwgroup-uk.com
1/5
Stock number white: 803/50402
Stock number grey: 803/50201
Stock number white: 803/50404
Stock number grey: 803/50202
Double

John Lewis 803/50402 Specifications

General

Model Number	803/50402
Brand	John Lewis
Bulb Fitting	E27
Maximum Bulb Wattage	60W
IP Rating	IP20
Type	Indoor
Product Type	Ceiling Lights

Summary

Introduction and Preparation

Pre-assembly Preparation

Ensure instructions are read in full before attempting assembly.

Assembly Requirements and Safety Precautions

Details product weight, assembly time, required people, and warnings about small parts and lifting.

Fittings and Parts Checklist

Step-by-Step Assembly Instructions

Step One: Attach Side Rails

Attach Side Rails to Headboard and Footboard using specified bolts and washers.

Step Two: Secure Cross Bars

Place Cross Bars onto Side Rails and secure with specified bolts and nuts.

Step Three: Attach Centre Rail and Legs

Attach Centre Rail to Cross Bars and Supporting Legs to Centre Rail.

Step Four: Install Wooden Slats

Attach Centre Plastic Holders to Centre Rail and Wooden Slats to Side Rails.

Care and Maintenance

Metal Care Instructions

Clean with a soft damp cloth, dry immediately, avoid harsh detergents.

General Safety Instructions

Always lift furniture, check fixings periodically, ensure competent adult assembly.